1975 PB300 5.9 360 intake

Discussion in 'Engine/Fuel/Exhaust' started by james88, Mar 17, 2017.

  1. james88

    james88 New Member

    Hello every one i got a new engine from advance auto parts Part No. DD06

    every thing work from my old engine but when i put intake in the water port shows in the middie
    is it post to be like this. ?
     

    Attached Files:

  2. james88

    james88 New Member

    cant get no feed back
     
  3. mrmopartech

    mrmopartech Moderator Staff Member

    This is a heat cross over port and the area exposed is normal,this is so the heat does not transffer to the rest of the head and burn the oil,mrmopartech 514 659 0445
     
  4. Bob Hogan

    Bob Hogan Well-Known Member

    Your good to Go James... :) Like Mr. Mopartech said... It's normal....
     
  5. james88

    james88 New Member

    thanks guys . Yea after look a a few videos on youtube i decide to put it together. funny thing is intake only use the 2 water ports the back water port are close off by intake..
     
  6. james88

    james88 New Member

    what tool do i need to remove the old oil filter nub out of the side block dumm dont come with new engine
     
  7. Bob Hogan

    Bob Hogan Well-Known Member

  8. james88

    james88 New Member

    Ok . Thanks for your feed back.
     

Share This Page